Product Care


Product Care

Bonded Performance Suits

Wingskin Bullet, Wingskin Pro
Iron Jammer 3, 2

ENGINE performance suites are designed using the most advanced hydrophobic premium fabrics utilising advanced compression technology and ultrasonically bonded seam construction.

In order to ensure that your new suit provides you with the best possible performance, we recommend you take the following precautions;

  • Rinse your garment in ONLY COLD water after each swim
  • DO NOT USE TOG WASH - This will cause the bonding of the suit to break down
  • Lay the suit flat to dry
  • DO NOT dry in direct sunlight
  • DO NOT tumble dry
  • DO NOT warm up in your suit
  • DO NOT cool down in your suit
  • DO NOT sit in the stands in your suit


All Male Swimwear including Briefs, Trunks & Jammers

All Female Swimwear including all one and two pieces

Although the best possible dyes and fabrics are selected, to ensure that your ENGINE swimwear remains in a good condition and retails its original appearance, please follow the care instructions below:

  • Never roll up and store when wet
  • Rinse thoroughly in cold water after use
  • Hand wash separately - Do not machine wash
  • DO NOT bleach, soak, tumble dry/spin dry clean or iron
  • Remove sand gently when swimwear is dry
  • Some colours may fade in chlorinated water or sunlight and became transparent when faded or wet
  • Dark colours may bleed or transfer

Please note we provide two general swimwear fabrics

  1. Recycled Nylon (78%) /  Elastene (22%) – High stretch. This requires extra rinsing in fresh water to remove chlorine, as the Elastene eventually breaks down
  2. Polyester (100%) – Super Chlorine Resistant. Low stretch fabric that requires less rinsing

Failure to follow care instructions will result in a void
of warranty with no exchange, returns or refunds.

Please watch this video for the correct way to tie your Wingskin Bullet drawstring.


Team Catalogue

Melbourne Store

Sydney Store

Engine Bikini

News, Deals & Exclusives